Kenwood KVT-M700 Instruction Manual page 38

Installation
■
Installing in Japanese-Made Cars-2
When the vehicle bracket is attached as in Toyota vehicles that use a
hole in the ● position in the figure below.
If this device can't be fastened with screws in the 2 places on the right and left due to the vehicle bracket shape, use the
installation fastener (Accessory J) and fasten the bracket.
1
J
Fasten Accessory
Accessory J
2
Fasten the vehicle bracket.
Accessory I
Screw (Provided with
the Audio Unit.etc)
3
Bend the point of Accessory J, and fasten the bracket.
38
or
on both sides as shown in the figure below.
Audio Unit.etc
Using a screwdriver or pliers bend the right
and left of Accessory J so that it can be
fastened to the vehicle bracket hole.
Not use the Hard Rubber Frame
( ).
Accessory E
Accessory J
Accessory I
Screw (Provided with
the Audio Unit.etc)