Cleaning And Lubrication; Required Maintenance At Ridgid Authorized Service Center; Accessories; Storage - RIDGID RP 330-B Manual

RP 330 Pressing Tool
RP 330 Pressing Tools

Cleaning and Lubrication

1. Daily wipe the tool clean with a clean dry cloth.
2. Inspect the attachment mounting pin and lubricate the
pin with silicone lubricant as needed.
3. Check return springs in attachments with each use.
Attachments should open and close freely with only
moderate finger effort required.
Required Maintenance at RIDGID
Authorized Service Center
After 30,000 cycles, the tool will show a blinking yellow
LED on the display panel as long as the tool is turned on
to indicate that it is time for maintenance and recalibration.
The tool will not run if it is not maintained within 2,000
more cycles after the yellow blinking LED begins.

Accessories

WARNING
Only the following tool accessories have been de-
signed to function with the RP 330 Pressing Tools.
Other accessories suitable for use with other tools
may become hazardous when used on the RP 330.
To prevent serious injury, use only the accessories
specifically designed and recommended for use
with the RP 330, such as those listed below.
Ridge Tool Company provides Standard Pressing
attachments designed specifically for use with
RIDGID Standard Pressing tools. Only use attach-
ments that are specifically designed to press the fit-
ting system you are installing. For a complete listing
of RIDGID attachments available for this tool, see
the Ridge Tool Catalog.
RP 330 Press Tool Accessories
Catalog
No. Description
27968 18V Lithium-Ion Battery Pack 2.2Ah
27958 115V Charger
27933 Carrying Case (Plastic)

Storage

Place the tool and jaws in its carrying case. Avoid storing
the tool, batteries or charger in extreme heat or cold.
The tool temperature sensor will not allow the tool to
turn on if oil temperature is not within the temperature
range of 15°F (-10°C) to 122°F (50°C). So it may be
necessary to allow the tool to warm or cool to a temper-
10
ature within the operating range by placing it in a condi-
tioned room for several minutes before use. This will be
indicated by a red glowing LED on the display panel.
WARNING
locked area that is out of reach of children and people
unfamiliar with the RP 330 Pressing Tool. The tool is
dangerous in the hands of untrained users.
Ridge Tool Company
Store the carrying case in a dry, secured,