Verify The Switch's Operation - HP J3100B Installation And Configuration Manual

3. Verify the Switch's Operation

This process verifies that the Switch 2000 is operating properly.
Verify the Switch Hardware
1.
2.
N o t e
Neither the Switch 2000 nor the RPS has a power switch. The Switch 2000 is
powered on when the power cord for either the switch itself or an installed
RPS is plugged into a power source.
If your installation requires a different power cord than the one supplied with
the switch, be sure to use a power cord displaying the mark of the safety
agency that defines the regulations for power cords in your country. The mark
is your assurance that the power cord can be used safely with the switch.
3.
Connect the supplied power cord to the switch's power receptacle.
Figure 1-3. Back Panel of the Switch 2000
Plug the power cord into a properly grounded electrical outlet.
Check the LEDs on the switch's front panel.
3. Verify the Switch's Operation
Power Receptacle on the
Back of the Switch, with
Power Cord Connected
Installing the Switch
1-5