Loading Film Into The M240 Module - AGFA QCR-Z Operator's Manual

Loading Film Into The M240 Module

• Position the film cassette so that it lays horizontally with the darkslide to the
left and with the releases at the top edge of the magazine.
• Open the cassette by pressing on the releases and unfolding.
• Place the 809 film into the cassette by placing the film lip under the film tab.
The film should align between the blue lines on the cassette. Close the cassette.
• Ensure that the darkslide is closed. Remove the film sleeve by pulling the
film from the side marked with the three arrows. Try not to pull the sleeve from
the side, this may cause the film to skew.
SLIDE THE 8 X 1 0 FILM
CASSETTE INTO SLOT
FILM
LIP
Figure 4-11. Loading the M240 Module
4-13
Operator Instructions
CASSETTE
RELEASES.
DARKSLIDE
FILM
TAB
QCR-Z Operator's Guide Version 4