Unloading 35Mm Film - AGFA QCR-Z Operator's Manual

Unloading 35mm Film

When the film advances past the last frame, the Error indicator is lit, and you
should now unload the film in the following way:
Figure 4-5. Unloading Film from the Chinon Camera
Send the unload film command from the host or use the QCR-Z's front panel
controls to initiate an unload film sequence. To do this, push the TEST button
down on the front panel until the unit beeps three times.
• Locate the film rewind button on the
under side of the camera.
• Slide the rewind button's protective
cover in the direction of the arrow to
provide access to the rewind button.
• Press the rewind button to rewind
the film.
• Remove the film from the camera
only after it is fully rewound and the
motor stops.
Slide protective cover
in direction of arrow
then press
Film Rewind Button
Locate the back cover release on the left side of the
camera. Open the back cover by pressing the release
button in, then sliding the lever downward. Remove the
film from the chamber.
Push button in
Slide lever downward
4-7
Operator Instructions
QCR-Z Operator's Guide Version 4