Warm Up Sequence; Operator Instructions - AGFA QCR-Z Operator's Manual

Operator Instructions

WARM UP SEQUENCE

IMPORTANT
Allow the QCR-Z to warm up for at least 20 minutes before you begin imaging.
The QCR-Z's front panel LED indicators will begin flashing after you turn the unit
on. The QCR-Z will perform internal intensity calibrations for red, green and blue
according to the type film module you are using. Once the system has calibrated
properly, the LED indicators will blank and the READY LED will illuminate.
Figure 4-1. Warm Up Sequence
QCR-Z Operator's Guide Version 4 4-2