Installing The Network Daughter Card; Internal Usb Memory Key (Optional); Replacing The Internal Usb Key - Dell PowerEdge R730 Owner's Manual

Rack servers
Hide thumbs Also See for PowerEdge R730:
Table of Contents

Advertisement

Installing the network daughter card

Prerequisites
1.
Ensure that you read the
2.
Follow the procedure listed in
3.
If applicable, remove the expansion card(s) in the expansion-card riser 2.
4.
Keep the #1 Phillips screwdriver handy.
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
Steps
1.
Angle the card so that the Ethernet connectors fit through the slot in the back panel.
2.
Align the captive screws on the card with the captive screw sockets on the system board.
3.
Press the touch points on the card until the card connector is firmly seated on the system board
connector.
4.
Using a #1 Phillips screwdriver, tighten the captive screws to secure the network daughter card to
the system board.
Next steps
1.
If applicable, install the expansion card(s) in the expansion-card riser 2.
2.
Follow the procedure listed in

Internal USB memory key (optional)

An optional USB memory key installed inside your system can be used as a boot device, security key, or
mass storage device. The USB connector must be enabled by the Internal USB Port option in the
Integrated Devices screen of the System Setup.
To boot from the USB memory key, configure the USB memory key with a boot image and then specify
the USB memory key in the boot sequence in the System Setup.
NOTE: To locate the internal USB connector on the system board, see

Replacing the internal USB key

Prerequisites
1.
Ensure that you read the
2.
Follow the procedure listed in
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
118
Safety
instructions.
Before working inside your
After working inside your
Safety
instructions.
Before working inside your
system.
system.
System board
system.
connectors.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Poweredge r730xd

Table of Contents