Using A Utility Sd Card; Supported Sd Cards; Inserting An Sd Card; Ejecting The Sd Card - Sony PXW-FS7 Operating Instructions Manual

XQD memory card replacement timing
• When the total remaining recording time on the
two memory cards becomes less than 5 minutes,
the message "Media Near Full" appears, the
recording indicator starts flashing, and a beep
sound (headphone output) will warn you.
Replace with media that has free space.
• If you continue recording until the total
remaining recording time reaches zero, the
message changes to "Media Full" and recording
stops.
Note
Up to approximately 600 clips can be recorded on one
XQD memory card.
If the number of recorded clips reaches the limit, the
remaining recording time indicator becomes "0" and the
message "Media Full" is displayed.

Using a Utility SD Card

You can save camera configuration data for the
camcorder on an SD card (available separately).
Saved data files can be imported from the SD
card.

Supported SD Cards

SDHC memory cards*
SD memory cards*
* Referred to collectively as "SD cards" in this manual.

Inserting an SD Card

1
Press the media cover release button
(page 10) to open the media cover of the
card slot section.
2
Insert the SD memory card with the SD
card label facing to the left.
The access indicator (page 10) is lit red, then
goes off if the card is usable.
3
Close the media cover.

Ejecting the SD Card

Press the media cover release button
(page 10) to open the media cover of the
card slot section, and lightly press the SD
card in to eject the card.
Notes
• If the camcorder is turned off or the SD card is
removed while the SD card is being accessed, the
integrity of data on the card cannot be guaranteed. All
data recorded on the card may be discarded. Always
make sure the access indicator is off before turning off
the camcorder or removing the SD card.
• Take caution to prevent the SD card from flying out
when inserting/ejecting the card.
28