6.5.1
Installation of the 1
Siemens Building Technologies
Fire Safety & Security Products
st
additional hard disk
Installation and replacement of hard disk drives
1. Remove the HDD frame by loosening
the four screws inside the device; then
disconnect all cables from the hard disk
unit within the HDD frame.
Note:
Be very careful when disconnecting the
data cables - they are not provided with
strain relief!
2. Fit the additional hard disk unit into the
cooling frame and secure it using the
four screws supplied with SISTORE
AX.
3. Now connect the data line as well as
the power supply line to both hard disks
(cable tie needs to be open).
Note:
When inserting the cooling frame make
sure the cables are not crushed or
damaged.
29
03.2009