Config Issues; Normal Booting; Message Displayed; Booting Without Hdd - Siemens SISTORE AX Installation Instructions Manual

Hard disk kit (sata)
Table of Contents

Advertisement

Technical check
5.1.1

Config issues?

5.1.2

Normal booting?

5.1.3

Message displayed?

5.1.4

Booting without HDD?

14
Siemens Building Technologies
Fire Safety & Security Products
1.
Verify BNC (SVHS) / VGA switch settings (either switch on the rear of the
device or via Display button on the front of the device)
2.
Stop recording when HDD is full
3.
Configuration of recording schedule and events
4.
Covert camera and colour control settings
1.
Verify System log
2.
Verify status of HDD in the Storage menu
3.
is it possible to enter the SMART menu from within the unit main menu?
Display of an HDD error code on the screen
The following list displays a list of relevant HDD error codes. In case one of
these error codes show on the screen the HDD needs to be replaced.
Code No.
Description
All installed HDDs are
1
defective.
All installed HDDs are
2
defective.
Creating database
3
failed.
HDD installed in
5
wrong DVR.
More than two HDDs
are installed in the
6
DVR, and error codes
2 and 5 occur
simultaneously.
"Disk Bad" alert in the OSD (Disk bad checks the amount of bad sectors on the
HDD).
SMART alert in the OSD
Message "There is no installed master HDD. Press OK button to shutdown."
Message "Setup not found".
Warning message (e.g. "WARNING: Immediately check storage").
Initializing message without proper booting and hang-up of the system.
Remove the power supply cable of the HDD and verify if it is working properly.
Cause
SYS_INFO can not be read
DISK_INFO can not be read
Creating database failed due to
HDD failure, incompatible HDD,
etc.
The HDD which was formatted
in one AX device was installed in
another AX device (e.g. HDD of
a 9-ch AX was installed in a 16-
ch DVR).
There are 2 HDDs installed. One
HDD has error code 2 problem
and another one has error code
5 problem.
Solution
Replace HDD and
perform Functional Test
Replace HDD and
perform Functional Test
Replace HDD and
perform Functional Test
Replace HDD or insert
correct HDD for this
device.
Perform Functional Test.
Replace HDD or insert
correct HDD for this
device.
03.2009

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents