Table of Contents
Advertisement
General features
2nd section
[2] button
Adjustment Item
Display
Front/Rear
"HPF"
High Pass Filter
[3] button
Adjustment Item
Display
Non-Fading
"LPF NF"
Low Pass Filter
[4] button
Adjustment Item
Display
Loudness
"LOUD"
[5] button
Adjustment Item
Display
Non-Fading level
"NF Level"
• Loudness: Compensating for low and high tones during low
volume.
• When the Dual Zone System is ON, the setting for the High Pass
Filter is nullified.
3rd section
[2] button
Adjustment Item Display
Volume offset
"V-Offset"
Volume offset: Each source's volume can be set as a difference
from the basic volume.
Range
Through/100/125/170 Hz
Range
50/80/120/Through Hz
Range
ON/OFF
Range
–15 — +15
Range
–8 — ±0
— 10 —
Speaker Setting
Fine-tuning so that the System Q value is optimal when setting
the speaker type.
1
Enter Standby
Press the [SRC] button.
Select the "ALL OFF" display.
2
Enter Speaker Setting mode
Press the [Q] button.
3
Select the Speaker type
Press the [2] — [5] button.
Each time the button is pressed the setting switches as shown
below.
Speaker type
OFF
For 5 & 4 in. speaker
For 6 & 6x9 in. speaker
For the OEM speaker
4
Exit Speaker Setting mode
Press the [Q] button.
Display Mode Switching
Switching the display mode.
1
Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "DISP" is displayed above the
[3] button.
Refer to <Notes on Multi-function Key System> (page 6).
Button
Display
[2]
"SP OFF"
[3]
"SP 5/4inch"
[4]
"SP 6*9/6inch"
[5]
"SP O.E.M."
Advertisement
Table of Contents
