Table of Contents
Related Manuals for Kenwood KDC-201
Summary of Contents for Kenwood KDC-201
- Page 1 KDC-201 KDC-101 CD-RECEIVER INSTRUCTION MANUAL CD-RECEIVER BEDIENUNGSANLEITUNG CD-PECИBEP ИHCTPУKЦИЯ ПO ЭKCПЛУATAЦИИ CD-РЕСІВЕР ІНСТРУКЦІЯ З ЕКСПЛУАТАЦІЇ Изделие изготовлено в Mалайзии © 2012 JVC KENWOOD Corporation B64-5057-10/01 (EW)
- Page 2 Declaration of Conformity with regard to the EMC Directive 2004/108/EC Manufacturer: JVC KENWOOD Corporation Information on Disposal of Old Electrical and Electronic Equipment and 3-12, Moriya-cho, Kanagawa-ku, Yokohama-shi, Kanagawa, 221-0022, Japan Batteries (applicable for EU countries that have adopted separate waste EU Representative’s: collection systems) Kenwood Electronics Europe BV...
- Page 3 Декларація про Відповідність Вимогам Технічного Регламенту Обмеження Використання деяких Небезпечних Речовин в електричному та електронному обладнанні (затвердженого Постановою №1057 Кабінету Міністрів України) Виріб відповідає вимогам Технічного Регламенту Обмеження Використання The marking of products using lasers деяких Небезпечних Речовин в електричному та електронному обладнанні (ТР The label is attached to the chassis/case and says that the component uses laser ОВНР). beams that have been classified as Class 1. It means that the unit is utilizing laser beams that are of a weaker class. There is no danger of hazardous radiation outside Вміст небезпечних речовин у випадках, не обумовлених в Додатку №2 ТР ОВНР: the unit. 1. свинець(Pb) – не перевищує 0.1 % ваги речовини або в концентрації до 1000 частин на мільйон; Kennzeichnung von Geräten mit Laser-Abtastern 2. кадмій (Cd)– не перевищує 0.01 % ваги речовини або в концентрації до...
-
Page 4: Table Of Contents
CONTENTS BEFORE USE BEFORE USE Warning Do not operate any function that takes your attention away from safe driving. BASICS GETTING STARTED Caution Volume setting: RADIO • Adjust the volume so that you can hear sounds outside the car to prevent accident. • Lower the volume before playing digital sources to avoid damaging the speakers by the sudden increase of the CD / USB / iPod output level. General: • Avoid using the USB device or iPod/iPhone if it might hinder driving safety. AUDIO SETTINGS • Make sure all important data has been backed up. We shall bear no responsibility for any loss of recorded data. -
Page 5: Basics
BASICS Faceplate Volume knob (turn/press) Loading slot Attach Detach Detach Display window button How to reset KDC - 201 KDC - 101 Your preset adjustments will also be erased. Do this (on the faceplate) Press and hold SRC. Turn on the power • Press and hold to turn off the power. Adjust the volume Turn the volume knob. Select a source Press SRC repeatedly. -
Page 6: Getting Started
; ACC2: Disables CD ejection and power-on for 30 minutes after the ACC switch is turned off. F/W UPDATE F/W UP xx.xx YES: Starts upgrading the firmware. ; NO: Cancels (upgrading is not activated). For details on how to update the firmware, see: www.kenwood.com/cs/ce/... -
Page 7: Radio
RADIO Default: XX LOCAL SEEK ON: Searches only FM stations with good reception. ; OFF: Cancels. Selects the tuning method for the 4 / ¢ buttons. SEEK MODE AUTO1: Automatically searches for a station. ; AUTO2: Searches for a preset station. ; MANUAL: Manually search for a station. -
Page 8: Cd / Usb / Ipod
Press and hold 4 / ¢. Reverse/Fast-forward Select a track/file Press from a list Turn the volume knob to make a selection, then press the knob. • Audio file: Select the desired folder, then a file. The source changes to USB and playback • iPod or KENWOOD Music Editor Light (KME Light)/ KENWOOD Music starts. Control (KMC) file * : Select the desired file from the list (PLAYLISTS, ARTISTS, ALBUMS, SONGS, PODCASTS * , GENRES, COMPOSERS * KDC - 201 iPod/iPhone ( only) • To return to the root folder (or first file), press number button 5. -
Page 9: Aux
CD / USB / iPod Preparation: Select a song by name Set the skip ratio Select [ON] for [BUILTIN AUX]. (➜ 4) KDC - 201 only) While listening to iPod ( KDC - 201 only) or KME While listening to iPod... Light/ KMC file... Start listening Press Press the volume knob to enter [FUNCTION]. Connect a portable audio player (commercially Turn the volume knob to select a category, then Turn the volume knob to select [SETTINGS], then... -
Page 10: Audio Settings
AUDIO SETTINGS While listening to any source... LOUDNESS LOUD LV1/ LOUD LV2: Selects your preferred low and high frequencies boost Press the volume knob to enter [FUNCTION]. to produce a well-balanced sound at a low volume level. ; OFF: Cancels. Turn the volume knob to select [AUDIO CTRL], then press the knob. BALANCE L15 to R15 (0): Adjusts the left and right speaker output balance. -
Page 11: Display Settings
Light” and “KENWOOD Music Control” Unplayable discs • This unit supports the PC application • Discs that are not round. “KENWOOD Music Editor Light” and Android™ • Discs with coloring on the recording surface or application “KENWOOD Music Control”. discs that are dirty. • When you use an audio file with database • Recordable/ReWritable discs that have not information added using the “KENWOOD Music been finalized. -
Page 12: Troubleshooting
TROUBLESHOOTING Symptom Remedy Symptom Remedy Sound cannot be heard. “USB ERROR” appears. • Adjust the volume to the optimum level. • Remove the USB device, turn the unit off, then turn it on • Check the cords and connections. again. • Try to connect another USB device. “PROTECT” appears and no Check to be sure the terminals of the speaker wires are operations can be done. insulated properly, then reset the unit. -
Page 13: Specifications
SPECIFICATIONS FM Frequency Range 87.5 MHz to 108 MHz (50 kHz space) USB Standard USB 1.1, USB 2.0 (Full speed) Usable Sensitivity (S/N = 26 dB) 7.2 dBf (0.63 μV/75 Ω) Maximum Supply Current DC 5 V File System FAT12/ 16/ 32 Quieting Sensitivity 15.2 dBf (1.6 μV/75 Ω) (DIN S/N = 46 dB) AAC Decode AAC-LC “.m4a”... -
Page 14: Installation / Connection
Installating the unit (in-dash mounting) Warning • The unit can only be used with a 12 V DC power supply, negative ground. Do the required • Disconnect the battery’s negative terminal before wiring and wiring. (➜ 13) mounting. • Do not connect Battery wire (yellow) and Ignition wire (red) to the car chassis or Ground wire (black) to prevent a short circuit. • Insulate unconnected wires with vinyl tape to prevent a short circuit. • Be sure to ground this unit to the car’s chassis again after installation. Make sure the direction Dashboard of of the trim plate. -
Page 15: Wiring Connection
Brown To the terminal that is grounded when either the telephone rings or during conversation. ( ×1 ) (Mute control wire) MUTE (To connect the Kenwood navigation system, consult your navigation manual.) E Extraction key Connecting the ISO connectors on some VW/ Yellow (Battery wire) Audi or Opel (Vauxhall) automobiles ( ×2 )