Yard Machines MTD599 Operator's Manual page 12

For Parts Call 606-678-9623 or 606-561-4983 For Parts Call 606-678-9623 or 606-561-4983
5. Wind the line onto the spool by turning the spool. The
line should go on in the direction of the arrow (A) on
the spool (Fig. 20). Line should be wrapped tightly
around the spool. The line is wound with each half
separated by the divider. Tightly wind it until there is
about 6" of line left (Fig. 21).
6. Lock the ends of the line in opposite slots on the
spool (Fig. 22). Place the clear plastic line retainer
back over the line and spool (Fig. 23). Pull the lower
line up into the lower slot in the clear plastic line
retainer (Fig. 24). Pull the upper line down into the
upper slot (Fig. 25).
7. Insert the line through each eyelet in the spool carrier
and slide the spool into the carrier. (Fig. 26)
NOTE: Ensure that the line is within the clear plastic
line retainer. If it's outside of the clear plastic line
retainer, the line will not feed.
A
Fig. 20
Fig. 21
Fig. 22
MAINTENANCE INSTRUCTIONS
www.mymowerparts.com www.mymowerparts.com
11
Fig. 23
Fig. 24
Fig. 25
Fig. 26