Husqvarna TC 450 Workshop Manual page 343

"KIT" ASSEMBLING INSTRUCTIONS
REAR TURN SIGNALS
Remove the saddle and left side panel as shown on page E.15-E16.
Assemble the turn signal flasher (5) on its holding plate (6)then fix them using
the air filter box side fastening screw.
Remove the rear tail light (see page M.30) then disconnect its cables from the
main wiring harness.
Fit the turn signal cables into the hole on license plate holder.
Fasten the turn signal using the nut M6 (3) and the spring washer (4).
Insert the turn signal cables between rear fender and license plate holder as
shown in the picture.
9
8
9
A
8
Part. N. 8000 H1344 (10-2009) O.13