Installing The Infant Restraint And Base Using Vehicle Belt - Graco SnugRide 35 Instruction Manual

3. Buckle the vehicle belt. Make sure the buckle
tongue goes into the correct buckle . The seat
belt should not be twisted or turned.
4. Tighten the vehicle seat belt. Refer to your
vehicle owner's manual and the instructions in "6.2.2 SAFE Vehicle
Belt Systems", page 29-31, on tightening your vehicle belt when
using the infant restraint without base.
To create a secure installation, push down
hard with your free hand on the infant
restraint and pull and tighten the
vehicle belt.
5. Test infant restraint for secure installation
as described in infant restraint "Final Safety
Check" page 40.
7.2 Installing the Infant Restraint and Base
Using Vehicle Belt
When using the base to install the infant
restraint, the lock-off is ALWAYS used to
secure both belts of the lap or lap/shoulder
belt.
1. Place the base in a rear-facing position
on a vehicle seat.
2. Open the lock-off and route the vehicle
belt through the belt path and over the
lock-off.
Lock-off
34
Lap Belt
Belts MUST go
under lock-off
3. To create a secure installation, while
pushing down on the base, pull the free
end of the lap belt or the shoulder portion
of the lap/shoulder belt to tighten
4. Close lock-off over lap belt AND free end or
the lap/shoulder belts .
Make sure that you push the top of the
lock-off all the way down.
5. Check that belt does not move by pulling
and pushing hard on base. If belt loosens
or lengthens, repeat procedure.
NEVER allow any object other than the
vehicle belts to go under or interfere with the
lock-off. If any other part of the vehicle belt
interferes with the lock-off choose another
seating location.
Lap/Shoulder
Belt
.
35