Graco SnugRide 35 Instruction Manual page 12

Shoulder Straps for a SMALLER Baby:
For infants 4-5 lbs. (1.8-2.3 kg) you must use the 2 part body
support, see page 18. Use the lower harness slots
even with or just below your child's shoulders) and the upper strap
loops . The ends of the straps must hang in front of the metal
junction plate as shown in , not as shown in
CHECK that the loops are completely
within junction plate slots .
CHECK that straps are secure by pulling
on them.
Shoulder Straps for a LARGER Baby:
Use middle or upper harness slots
CHECK that the loops are
completely within junction
plate slots .
CHECK that straps
are secure by pulling
on them.
(if they are
.
and the end strap loops .
22
To Shorten Waist Straps for a SMALLER Baby:
For infants 4-5 lbs. (1.8-2.3 kg) you must use the
2 part body support, see page 18. The length of the
waist strap can be shortened further by pushing aside
the small tab that holds the anchor clips in place and
pull the anchor clips out of their indentations
the anchor clip to the second loop in the strap
CHECK that anchor clips are threaded properly. The ends of the straps
must be inserted under the storage tabs as shown in
clip into the seat indentations. Repeat on other side.
CHECK that straps are secure by pulling on them from the front of the
seat.
To Lengthen Waist Straps for a LARGER Baby:
Remove the anchor clip from the seat
end of the strap. CHECK that the anchor clips are threaded properly
Snap anchor clips back
into seat as shown in .
11
Repeat on other side.
CHECK that straps are
secure by pulling on them
from the front of the seat.
. Move
.
. Snap anchor
. Move the anchor clip to the
BL
23
.
11