Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Graco Trax Jogger
Summary of Contents for Graco Trax Jogger
- Page 1 MODES™ JOGGER • featuring • Owner’s Manual ©2016 Graco PD349313B...
- Page 2 3-H Child’s Tray 4 Use To Secure Child To Recline Brakes 4-D Swivel Wheel Remove the Wheels To Use Tether 4-G To Attach a Graco® Infant Car Seat 4-H To Fold Stroller • Pliage la poussette• Para plegar el cochecito...
- Page 3 5 Cleaning Care & Maintenance Replacement Parts...
- Page 4 AVOID SERIOUS INJURY from parcels or accessory items on the falling or sliding out. Always use handle (other than approved Graco seat belt or infant car seat stroller bags). Never place harness. After fastening buckles, anything on the canopy.
- Page 5 DO NOT use stroller for jogging READ THE MANUAL provided while carrier is in stroller. with your Graco car seat before using it with your stroller. BE AWARE of the increased speed and greater possibility of FALL HAZARD: Always check that losing control of the stroller.
- Page 6 2-A Parts List This model may not include some features shown below. Check that you have all the parts for this model BEFORE assembling your product. Tools required: Phillips Screwdriver All models...
- Page 7 To Open Stroller Be sure to place stroller on top of a piece of cardboard or some other protective cover to prevent any damage to floor. Cut cable ties Carton • Boîte • Caja CHECK that the stroller is completely latched open before continuing.
- Page 8 Front Wheel CHECK the tire pressure before using the stroller. DO NOT INFLATE above the maximum recommended inflation pressure that is written on the side of the tire. Over-inflation may cause wheel and/or tire to blowout and could result in serious injury. DO NOT use air compressor to inflate tire.
- Page 9 1. Attach front wheel to stroller as shown. 2. Check that wheel is securely SNAP! attached by pulling on wheel ENCLENCHEZ! assembly. ¡CRAC!
- Page 10 Rear Wheels WARNING Choking Hazard: Remove and immediately discard protective end cap from each wheel. DO NOT remove rear wheels unless replacing them. Child could fall on exposed rear axle and be injured. 1. Remove and immediately discard protective end cap from each wheel.
- Page 11 2. Attach rear wheels to stroller as shown. SNAP! ENCLENCHEZ! ¡CRAC! 3. Check that wheels are securely attached by pulling on wheel assemblies. 4. Stand the Trax Jogger upright.
- Page 12 Install Rear Basket 1. Insert the rear basket frame into the mounts until it is locked in place. SNAP! ENCLENCHEZ! ¡CRAC! 2. Pull on the frame to make sure that it is fully latched.
- Page 13 Canopy 1. Insert canopy wire into the canopy mounts on each side of the stroller as shown. 2. Use a Philips screwdriver to insert screw into canopy mount as shown. Repeat on other canopy mount.
- Page 14 3. Place the back of the canopy over the loops and fasten hook and loop tabs as shown. MAKE SURE canopy is always fastened with the hook and loop tabs when used with infant car seat or when toddler seat is in use.
- Page 15 5. Push backwards to close canopy. 6. Pull flap forward to open and backward to close canopy win- dow. 7. Pull canopy visor out for use, push back under rim of canopy when not in use.
- Page 16 Parent’s Tray 1. Open the canopy. 2. Insert tray into slots. Make sure the tray is latched on each side. SNAP!
- Page 17 Lift the cover to access storage. To Adjust Handle To adjust handle, press buttons on both sides of handle and rotate handle.
- Page 18 3-H Child’s Tray WARNING Always secure your child with the seat belt. The tray is not a restraint device. DO NOT lift the stroller by the child’s tray. Use care when snapping the tray on the stroller with a child in the stroller. 1.
- Page 19 2. Twist end of tray downward until it latches. SNAP! 1. To open the tray: a. Pull the tab forward as shown. b. Lift the tray from the cup holder. 2. Close the tray: lower the tray until it latches. SNAP!
-
Page 20: Point Harness
To Secure Child WARNING Falling Hazard: Always use the seat belt. 5 Point Harness 1. To open, press button on buckle to release the waist straps. 2. To close, slide shoulder strap connectors onto waist straps and insert into buckle. - Page 21 3. Use slide adjuster at shoulder and waist for tighter adjustment. To Use slide adjuster at sho change shoulder harness slots, waist for further adjustm see page 30-31. Repeat on other side. Utilisez le régulateur cou à l'épaule et à la taille po ajustement plus précis.
- Page 22 3 Point Buckle 1. To open, press button on buckle to release the waist straps. 2. Slide shoulder strap connectors off of waist straps. 3. Remove shoulder straps from stroller.
- Page 23 4. Attach waist straps to harness buckle as shown. 5. Use slide adjuster at waist for tighter adjustment. 6. To open, press button on buckle to release the waist straps.
- Page 24 Adjusting Shoulder Harness position Shoulder harness anchor—larger child Shoulder harness anchor—smaller child Slide adjuster...
- Page 25 Push harness anchor through the front of the seat then re-insert through desired slots at the same height level. Use either shoulder harness anchor in the slots that are closest to child’s shoulder height. Use slide adjuster for further adjustment.
- Page 26 To Recline WARNING When making adjustments to the stroller seat, make sure child’s head, arms, and legs are clear of moving seat parts and stroller frame. 1. To recline, push lever down and pull seat back downward. 2. To raise, position and hold the seat back as desired, pull the strap tight.
- Page 27 Brakes WARNING Always apply both brakes. CHECK that brakes are on by trying to push stroller. 1. Push down both brakes to lock brakes. SNAP! 2. Push up both brakes to unlock brakes. SNAP!
- Page 28 Swivel Wheel WARNING FALL HAZARD from tip over. Before running, jogging or walking fast, LOCK the front wheel from swiveling. Front swivel wheel locks for use on uneven surfaces such as grass, stones or gravel. SNAP! ENCLENCHEZ! ¡CRAC!
- Page 29 Removing Wheels Front Wheel For easy transport or storage, remove front wheel by pushing button as shown.
- Page 30 Rear Wheels WARNING DO NOT remove rear wheels unless replacing them. Child could fall on exposed rear axle and be injured. To remove wheel, push button and pull wheel off. Repeat with the other wheel.
- Page 31 To Use Tether The tether strap is intended to maintain control of the stroller in the case of a fall while running. DO NOT allow tether strap to lie over top of the handle. DO NOT hang items on the tether strap. To use tether, remove tether from the handle or basket, then attach to your wrist as shown.
- Page 32 Use only a Graco® SnugRide® Click Connect™ car seat with this stroller. This stroller is only compatible with Graco® SnugRide® infant car seats with Click Connect™. Only use with Graco® infant car seats that have the Click Connect™ logo. Improper use of this product with a car seat may result in serious injury or death.
- Page 33 1. Recline the toddler seat back to lowest position. 2. Find mounts in toddler seat. 3. Insert car seat into stroller and push down on car seat until the latches snap into the Click Connect™ mounts. SNAP!
- Page 34 4. Check that infant car seat is securely attached by pulling up on it. 5. To remove car seat, squeeze release handle at back of car seat and lift car seat out of the stroller.
- Page 35 To Fold Stroller 1. Before folding stroller: (a) remove infant car seat if in (b) lock brakes SNAP! 2. To fold: (a) slide button then (b) rotate handle toward you.
- Page 36 3. (a) Lift the handle to unlatch the frame. (b) Grasp the infant cupholder and move it toward you to fold the frame. 4. Release the handle and latch the frame in the folded position. SNAP!
- Page 37 FROM TIME TO TIME CHECK YOUR STROLLER for loose screws, worn parts, torn material or stitching. Replace or repair the parts as needed. Use only Graco replacement parts. EXCESSIVE EXPOSURE TO SUN OR HEAT could cause fading or warping of parts.