Graco SnugRide 35 Instruction Manual page 16

Lap Belts with Automatic
Locking Retractor (ALR)
Combination Lap/Shoulder Belt
with Locking Latch Plate
The automatic locking
retractor will not permit the
lap belt to lengthen once it is
buckled. Tighten the belt by
feeding the belt back into the
retractor while pushing down
hard on the infant restraint.
Once it is buckled, this type of
belt has a latch plate that will not
allow the lap portion of the belt to
loosen. Belt is tightened by pulling
hard on the shoulder portion of the
vehicle belt while pushing down
hard on the infant restraint.
30
Combination Lap/Shoulder
Belt with Sliding Latch
Plate
Locking clip
To Install Locking Clip: (DO NOT use with base)
1. Tighten the buckled belt by pushing down
hard on the infant restraint and pulling hard
on the shoulder belt.
2. While pushing down on infant restraint, pinch
the two straps together behind the buckle
tongue. Unbuckle the belt
without allowing it to slip.
3. Connect lap and shoulder belts
with locking clip as shown
and .
4. Rebuckle belt. Check that lap belt
does not move by pulling and
pushing hard on infant restraint.
If belt loosens or lengthens,
repeat procedure.
This belt has a latch plate that slides
freely along the belt.
This belt MUST be converted to prevent
movement of the lap portion of the belt.
You must use a locking clip (provided
with the infant restraint) when using the
infant restraint without the base unless
your vehicle's seat belt can be
converted in another way as described
in your vehicle owner's manual.
Locking clip goes here,
/ inch (1 cm) from the buckle
1
2
31
/ inch
1
2
(1 cm)