Wifi Setting; Remote Access Setting - Aztech WIPC409HD User Manual

User Manual

WIFI Setting

The wireless settings page is as shown above. You can click the "Search" button,
and it will show you a list of WIFI networks detected. By selecting one SSID, all
data fields will be filled up automatically (e.g. SSID, encryption algorithm etc.).
All you have to do is to enter the wireless password in the Key and the Re-Type
Key field correctly. Click the Check button to check if the parameters entered
are correct. You may then click the Apply button to apply the settings.
Note: Before you set up wireless parameters, ensure that the device is
connected to the Internet. After connecting successfully, reboot the device for
the wireless settings to take effect. Upon rebooting the device, it will take 30
seconds before the camera will automatically pan and tilt by itself. Another (2)
minutes is needed for the camera to successfully establish a wireless connection
to the router.

Remote Access Setting

 Manufacturer's DDNS and Third Party Dynamic DNS. Please refer to the
content of the part DDNS.
 UPNP. UPNP stands for universal plug and play. If you enabled UPNP, once the
IP camera is connected into the LAN, it will communicate with the router of
the LAN. It will request the router to open a port to forward its own port.
NOTE : Before using UPNP function, please ensure that the router's UPNP has
also been enabled. It is also important to know that some routers do not
support a UPNP feature. If it does not have the said feature, it is suggested to
set a Port Forwarding Function on your router.
 WAN IP Test. Click the "Show" button, it will show you another page displaying
the WAN IP address when it is connected to the Internet.
21