User Manual
Visit IP Camera from LAN
Set IP Address
The IP addresses of each IP Camera and PC should be on the same segment or
IP range. As explained earlier, you would not be able to access IP Camera-1.
To change the IP address of IP Camera-1:
1. Run the WIPC409HD Utility in the CD.
2. Click Find button, and then select the IP Camera to set the IP Camera's IP
address.
Additional Notes:
If a firewall is enabled in your PC, a popup window will ask for your
confirmation if you would be blocking or allowing the software to run. Click
Allow to proceed.
IP Cameras by default use a dynamic IP Address and an HTTP port 8081. If
you do not have this software, you could also press down the reset button of
the IP Camera (found at the bottom of the camera) to reset it to its default
factory settings. You can then use the default IP address to visit the IP
Camera.
10