Table of Contents
Advertisement
¡á Overview
Rear View
¨ì
¨í
¨î
¨ï
¨ì OSD Setup Buttons
¤ýSET Button : Displays the menu on the screen. Press this button to confirm
status or after changing a selected item.
¤ýUp and Down Button : Used to move the cursor up or down in the menu
screen to select a desired menu item.
¤ýLeft and Right Button : Used to move the cursor left or right in the menu
screen or to change the value of the selected item.
¨í D & N Input Port (GND : BW, Open : Colour)
Switch to Day or Night Mode by connecting an external signal to this port.
¨î MD Output Port
Motion detection signal is output through this port.
3±0.5sec
0V
There is motion
¨ï RS-485 Control Port
The SETUP MENU can be controlled via this port using an external controller that
supports RS-485 communications. For details, see page 19.
¨ð Power LED
When power is properly connected, the LED illuminates.
12
WDR True Day&Night Camera
¨ð
¨ñ
¨ò
¨ó
+4.0V ~ +4.5V (less than 10mA)
There is motion
Installation Procedures ¡á
¨ñ Video OUT Port
Video signals are output through this port. Connect this port to the Video IN
port of a Monitor/DVR.
¨ò Auto iris lens selection switch
Used to change between DC or Video depending upon the type of
auto iris in use.
¨ó Power IN Port
Connections for camera power, as specified for each model.
Lens
The lens is not supplied with this camera. Purchase a lens suitable for
the environment. This camera accepts an auto iris lens, and both
C-and CS-mount lenses.
Note
• It is recommended to use the DC type Auto Iris Lens to effectively
enjoy the major functions of this camera.
• Keep the lens surface clean, as the picture quality suffers if
there is dirt or fingerprints on the Lens.
Using an Auto Iris Lens
1. Strip 8mm of insulation from the end of the Auto Iris Lens cable..
2. Strip 2mm of insulation from each of the cores of the cable.
approx. 8mm
approx. 2mm
13
WDR True Day&Night Camera
Advertisement
Table of Contents
