Table of Contents
Advertisement
7 Removal of Dome Cover and Camera Assembly
a. Using the supplied Torx T-20 security tool, loosen the four tamper-proof
screws holding the dome cover to the enclosure assembly. Note these screws
are captive. These screws should not be removed from the dome cover trim
ring.
b. Lift the dome cover and trim ring away from the camera assembly.
c. Locate the removal tabs where the camera assembly connects to the
mounting plate as shown in Figure 7.1.
Figure 7.1
d. Press any two of the three removal tabs and pivot the camera assembly up
and away from the mounting plate.
Removal Tabs
7
Advertisement
Table of Contents
