Fault Indications - Asko DW70 Service Manual

PROGRAMS AND CONTROl UNIT
DW70.5
1. Turn off the main power switch (I/0).
2. Wait at least 5 seconds.
3. Press and hold the Program and Start buttons
(S1 and S2).
4. Switch on the main power switch (I/0).
5. Release the Program and Start buttons (S1 and
S2) when the LEDs have lit.
The most recent fault is shown in display D2 and
D3. Error messages are erased by a total reset.
Press S1 to activate the component test. These are
activated in order after each button press and are
shown in display D3.
1. Inlet valve and mixer valve (mixer valve open 1
second) then inlet valve open.
2. Only inlet valve open.
3. Salt water valve (salt and mixer valve only in
machines with water softener)
4. Combi dispenser
5. Circulation pump
6. Circ. pump and element (max. 75°C)
7. Fan and Vax motor
8. Drain pump
Adjust water intake (in service menu)
Press the Program button (S1) for 3 seconds to
activate the menu for setting the water intake.
Then use the Program button (S1) to step
through.
The display shows:
P:0 = Normal water intake volume
P:5 = Water intake volume increases by 5%
P:10 = Water intake volume increases by 10%
P:15 = Water intake volume increases by 15%
T:0 = Normal water intake volume
T:5 = Water intake volume increases by 5%
T:10 =Water intake volume increases by 10%
T:15 =Water intake volume increases by 15%
P = water intake controlled by flow meter
T = water intake time-controlled
Confirm selection by pressing Start (S2). The
program returns to the main menu.
DW70.C
1. Turn off the main power switch (I/0).
2. Wait at least 5 seconds.
3. Press and hold the Program and Start buttons
(S1 and S2).
4. Switch on the main power switch (I/0).
5. Release the Program and Start buttons (S1 and
S2) .
The display lights up in five seconds.

Fault indications

Latest occurd fault indicates F1. F2 and so on, on
the display
Component test
Press S1 to activate the component test and step
through the following components:
1. Inlet valve
2. Salt water valve (only in machines with water
softener)
3. Detergent and rinse aid dispenser
4. Cirkulation pump
5. Heater and cirkulation pump
(Max 85°C)
6. Fläkt
7. Avloppspump
Adjust water intake
Hold the program button until "1" in the display
extinguished. Now, the water intake is adjustable
according to below:
Press the program button and step trough:
The displays shows:
Normal water intake volume
0:
Water intake volume increases by 5%
1:
Water intake volume increases by 10%
2:
Water intake volume increases by 15%
3:
4: Time-controlled water intake
5: Time-controlled water intake increases by 5 %
6: Time-controlled water intake increases by 10 %
7: Time-controlled water intake increases by 15%
Confirm selection by pressing Start (S2).
The program returns to the main menu.
27