Asko DW70 Service Manual page 8

INSTAllATION
Connection to water supply
The supply pipe must be fitted with a stop-
cock. The stopcock should be positioned
above the sink unit or at the front of the sink
unit cabinet.
The inlet pipe has a coupling with either a 1/2"
or a 3/4" internal thread, depending on the
country.
Once the machine in installed: Open the stop-
cock to flush the pipe. Check that all connec-
tions are watertight.
electrical connection
Machines fitted with a cable and plug must be
connected to an earthed socket.
Technical data
See the type plate on the right-hand side of
the door.
CAUTION!
The power cable must be disconnected or the
power to the socket turned off when work is
carried out!
Drain connection
• The drain hose connects to a connection
nipple on the sink unit's water trap (see illus-
tration below). Note that the hose must be at-
tached at the same height as the underneath
of the sink unit otherwise dishwater from the
sink may run down into the dishwasher (see
illustration).
• The drain hose connects to a connection
pipe on the sink unit's water trap. It must have
an internal diameter of at least 16 mm.
• The drain hose may be extended to a maxi-
mum of 3 m. Any connections and connect-
ing pipes must have an internal diameter of at
least 16 mm.
8
• No part of the drain hose may be more than
950 mm above floor level.
The hose must not be routed directly to the
floor drain or similar. In such cases, the hose can
act as a siphon and empty the machine.
The hose must always discharge at least 350
mm above floor level.
• Attach the hose holder.
(Min. 350 mm and max. 950 mm above floor
level.
hose holder
Max 950 mm
Min 350 mm
Figure 3.