Scan Set Mode - Icom IC-756PROII Instruction Manual

Scan set mode

Scan set mode is used for programming scanning
speed and scan resume condition.
• Scan speed
The transceiver has 2 speeds for scanning, high and
low.
q Push [EXIT/SET] several times to close a multi-
function screen, if necessary.
w Push [(F-5)SCAN] to select the scan screen.
ANT ANT
2.4k 2.4k 0
BW BW SFT SFT
1
TX T X VFO VFO U S B U S B
qr.qot.pp
METER METER
Po Po
1 14.100.00 14.100.00
P.AMP P.AMP
1 VFO VFO USB USB
qr.wpt.pp
ATT ATT
OFF OFF
1 14.100.00 14.100.00
AGC AGC
MID MID
VOX VOX
OFF OFF
∂ F S p a n S p a n : ±
COMP COMP
P r o g r a m m e d P 1 : P r o g r a m m e d P 1 :
OFF OFF
s c a n e d g e s s c a n e d g e s P 2 : P 2 : 2 9 . 9 9 9 . 9 9 M H z
WIDE WIDE
∂
PROG PROG F FINE FINE
e Push [(F-5)SET] to select the scan set mode
screen.
r Push [(F-1)Y] to select the scan speed item.
AGC AGC
S C AN Sp ee d S C A N S p e e d
MID MID
S C A N R e s u m e S C AN Re su me
VOX VOX
OFF OFF
COMP COMP
OFF OFF
WIDE WIDE
é è
DEF
t Rotate the tuning dial to select the scan speed.
• Push [(F-3)DEF] to select the default condition.
y Push [EXIT/SET] to exit the scan set mode.
qw:pp
FIL2 FIL2
USB USB
FIL2 FIL2
USB USB
SCAN SCAN
± 1 0 k H z 1 0 k H z
0 . 5 0 0 . 0 0 M H z 0 . 5 0 0 . 0 0 M H z
2 9 . 9 9 9 . 9 9 M H z
∂
F SPAN F SPAN SET SET
S C A N S E T
H I G H H I G H
O N O N
• Scan resume condition
This item sets the scan resume function ON or OFF.
ON: scan resumes 10 sec. after stopping on a signal
(or 1 sec. after a signal disappears); OFF: scan does
not resume after stopping on a signal.
q Push [EXIT/SET] several times to close a multi-
function screen, if necessary.
w Push [(F-5)SCAN] to select the scan screen.
e Push [(F-5)SET] to select the scan set mode
screen.
r Push [(F-2)Z] to select the scan resume condition
item.
AGC AGC
S C A N S p e e d SCA N S pe ed
MID MID
SCA N R es ume S C A N R e s u m e
VOX VOX
OFF OFF
COMP COMP
OFF OFF
WIDE WIDE
é è
DEF
t Rotate the tuning dial to turn the scan resume
function ON or OFF.
• Push [(F-3)DEF] to select the default condition.
y Push [EXIT/SET] to exit the scan set mode.
SCANS
SC AN S ET
H IGH H I G H
O N O N
7
61