Fisher & Paykel Built-in oven Quick Start Manual

QUICK START GUIDE

Built-in oven
NZ AU GB IE
Keep this document handy for easy reference.
For detailed information on the other features of your oven, see your 'User guide'.
Before using your oven, make sure you read the full 'User guide', with special attention to the 'Safety and warnings' section.
For contact information or if you require service, assistance or replacement parts, see the end of this document or your 'Service & warranty'
booklet.
YOUR OVEN
Control panel
1
Oven vent louvres
2
Step down oven wire shelf
3
4 Oven light
5 Telescopic sliding shelf
Side rack
6
Oven wire shelf
7
8 Oven door and handle
9 Oven seal
OB60SL9DEX
Accessories:
Grill rack
10
11 Smokeless grill tray
Deep Roasting dish
12
Flat baking tray
13
Catalytic panels
14
THE CONTROL PANEL
Function indicators
(see 'Oven functions')
Rotisserie indicator
(see 'Using the
Rotisserie') in the
User guide
if lit:
Control lock indicator (see
Rotisserie is
'Locking the control panel')
in use
if lit:
Control panel is locked
Locking the control panel
To lock, press and hold the select
button for 2 seconds.
To unlock, press and hold the
cancel button for 2 seconds.
9
1
2
3
4
5
6
7
8
Function dial Temperature
indicator
Function halo
F U N C T O I N
Timer indicator
(see 'Using the
timer')
Cooking time indicator (see 'Automatic cooking') in User guide
if lit:
Timer is counting
if lit:
down
Automatic cooking time is set
Display
Stop time indicator
(see 'Automatic cooking') in User guide
Scroll Select Cancel
if lit:
Automatic stop time is set
SETTING THE CLOCK
You set the clock within the user preference menu. To learn more about the user preference menu, refer to your User guide.
Note: If you do not wish to set the time initially when the oven is first switched on at the wall, press the cancel button to exit the clock setting.
If you want to set the clock later, follow the steps under 'To change the time' .
When the oven is first switched on at the wall
24 H r.
The display will flash
1
10
11
12
13
Press the left and right scroll
3
14
buttons to set the time.
FIRST USE
Important!
Before using your oven for the first time, you should fit both
the Catalytic Panels (supplied). See 'Care and cleaning' in
your user guide for details about these self cleaning panels.
You do this by:
removing ALL the cable ties holding the shelving in place,
Temperature
if the installer has not already done so.
Temperature
dial
halo removing the shelves and side racks
fitting the catalytic panels
E T M P R E T A U E R
replacing the side racks and shelves
We recommend you then condition the oven.
Follow the steps below to fit the Catalytic Panels.
2 REMOVE ALL SHELVES FROM THE OVEN
1 Remove all the shelving, taking special care with the telescopic
sliding shelves.
To remove a telescopic sliding shelf, grip it at the front (making
2
sure you are gripping the wire shelf and the sliding frame
together), lift upwards and pull it out of the oven.
For your safety, the wire shelf and telescopic sliding frame are
built together as one unit and are not separable.
2a Press the right scroll button to scroll
1
24 H r 12 H r
between and
Press the select button to confirm.
2b
2
3
Press the select button to confirm.
4
The time set will now be steadily lit.
1 REMOVE ALL CABLE TIES & PACKAGING HOLDING
THE SHELVING IN PLACE
3 REMOVE BOTH SIDE RACKS
Remove both side racks by 1)
pushing down on the retaining
wire until it clears the lower lock
stud and swing out wards to 2)
clear the upper lock studs, then
3) lift out.
lock stud
retaining wire
To change the time
(within the user preference menu)
Press and hold the left and right scroll
buttons together for 3 seconds
to enter the user preference menu.
12 H r
24
The display will either show or
H r
Press the select button to confirm.
The display will flash.
Follow steps 2-5 left to set the time.
At step 2a, you also now have the
24 H r
ability to scroll between ,
12 H r OFF
and (turns the display off ).
Refer to the User guide to learn more
about this feature.
2
2
1
3
continued over