Precautions - Icom i2730A Instruction Manual

Dual band
Table of Contents

Advertisement

PRECAUTIONS

R DANGER HIGH VOLTAGE! NEVER
connector during transmission. This may result in an electrical
shock or burn.
R WARNING RF EXPOSURE!
dio Frequency (RF) energy. Extreme caution should be observed
when operating this transceiver. If you have any questions re-
garding RF exposure and safety standards please refer to the
Federal Communications Commission Office of Engineering and
Technology's report on Evaluating Compliance with FCC Guide-
lines for Human Radio Frequency Electromagnetic Fields (OET
Bulletin 65).
R WARNING! NEVER
operate the transceiver while driving
a vehicle. Safe driving requires your full attention—anything less
may result in an accident.
R WARNING! NEVER
operate the transceiver with an ear-
phone or other audio accessories at high volume levels. Continu-
ous high volume operation may cause a ringing in your ears. If you
experience ringing, reduce the volume level or discontinue use.
R WARNING! NEVER
connect the transceiver to an AC out-
let. This may pose a fire hazard or result in an electric shock.
R WARNING! NEVER
connect the transceiver to a power
source of more than 16 V DC such as a 24 V DC. This could
cause a fire or damage the transceiver.
R WARNING! NEVER
reverse the DC power cable polar-
ity when connecting to a power source. This could damage the
transceiver.
touch an antenna
This transceiver emits Ra-
R WARNING! NEVER
cut the DC power cable between the
DC plug and fuse holder. If an incorrect connection is made after
cutting, the transceiver may be damaged.
R WARNING! NEVER
let metal, wire or other objects touch
any internal part or connectors on the rear panel of the trans-
ceiver. This may result in an electric shock or this could cause a
fire or damage the transceiver.
R WARNING! NEVER
operate or touch the transceiver with
wet hands. This may result in an electric shock or may damage
the transceiver.
R WARNING!
Immediately turn OFF the transceiver power
and remove the power cable if it emits an abnormal odor, sound
or smoke. Contact your Icom dealer or distributor for advice.
CAUTION: NEVER
expose the transceiver to rain, snow or
any liquids.
CAUTION: NEVER
change the internal settings of the trans-
ceiver. This may reduce transceiver performance and/or damage
to the transceiver.
CAUTION: NEVER
place the transceiver where normal op-
eration of the vehicle may be hindered or where it could cause
bodily injury.
DO NOT
operate the transceiver near unshielded electrical
blasting caps or in an explosive atmosphere.
DO NOT
push the PTT when not actually desiring to transmit.
ii

Advertisement

Table of Contents
loading

This manual is also suitable for:

I2730eIc-2730aIc-2730e

Table of Contents