Troubleshooting - Grundig Sonoclock 890 WEB Manual

Problem
No sound.
The device does not respond to
button commands.
The remote control does not
work.
Poor radio reception.
Problem
Desired WLAN network not
found.
Connection to router not
established.
Music playback is briefly
interrupted.
54
INFORMATION

Troubleshooting

Not every kind of sound interference is caused by a defect in your
device. Cables that have accidentally been disconnected and flat
batteries for the remote control will impair functioning. If the follow-
ing measures do not resolve the problem satisfactorily, please visit
www.grundig.com or contact your specialist dealer.
General faults
Possible cause/remedy
The volume setting is too low – increase the volume. The head-
phones are plugged in – disconnect the headphones. Power
cable is not properly connected, connect the power cable prop-
erly.
Static electrical discharge. Switch off the device – disconnect the
power cable and plug it in again after a few seconds.
The batteries are flat – replace the batteries.
The remote control is out of range of the device.
Weak antenna signal, check antenna.
Weak FM stereo signal, switch to mono.
Interference from electrical devices such as televisions, video
recorders, computers, neon lamps, thermostats or motors.
Keep the hi-fi away from such equipment.
Internet faults
Possible cause/remedy
– WLAN network is deactivated, switch on the WLAN network.
– SSID is suppressed on the router; display SSID on the router.
– Distance to router is too large; reduce distance to router.
– MAC address of the device is not enabled on the router;
enable MAC address (see menu item »Info«) on the router.
– Data transfer from the router is encrypted; Enter the network key
(WEP or WPA) on the device.
If this does not help, check the entire router configuration.
High network usage on the radio station server.
------------------------------------------------------------------------------