Netfinity Manager For Windows Nt System Requirements - IBM 21Y Maintenance Manual

Note: Serial Connection Control will not function on sys-
tems that do not have a properly installed and config-
ured modem.
Netfinity Manager for Windows NT
system requirements
The minimum system requirements for Netfinity Manager for
Windows NT are:
• Microsoft Windows NT version 4.0 or later
• Approximately 17 MB–20 MB of hard disk space
(space required depends on system configuration)
• A LAN adapter card and one or more of the following
communications protocols:
— TCP/IP (must be WinSock Version 1.1-compati-
ble; required for Netfinity Manager with Web
Enhancement)
— NetBIOS
Note: The Netfinity Manager NetBIOS require-
— IPX
— SNA (Microsoft SNA Server version 2.11 with Ser-
vice Pack 1 and WCPIC32.DLL dated 01/22/97 or
later. This DLL is available from Microsoft)
Note: Systems using Netfinity Manager with Microsoft
SNA Server cannot communicate with systems
that run the Microsoft SNA Server client. Netfin-
ity Manager supports only server-to-server com-
munications between systems that run Microsoft
SNA Server software. However, Netfinity Man-
ager systems running Microsoft SNA Server can
communicate with other Netfinity Manager sys-
tems using any of the other supported SNA
stacks.
• A 9600 baud or greater modem (optional).
The hard disk requirement for Client Services for Netfinity
Manager is 6.5 MB–9 MB of hard disk space. All other sys-
tem requirements are the same as for Netfinity Manager for
Windows NT.
Notes:
1. Serial Connection Control will not function on systems
that do not have a properly installed and configured
modem.
2. To most effectively manage Windows NT systems, any
user that will be using Netfinity Manager on a Windows
NT system (locally or remotely) must have administra-
tor-level access to the system.
ments are three names, two sessions, and
nine network control blocks (NCBs).
Netfinity Manager
79