IBM 21Y Maintenance Manual page 149

Setup
Netfinity Setup and
Installation CD won't
start.
ServeRAID program
cannot view all
installed drives - or -
cannot install NOS.
The Operating
System Installation
program
continuously loops.
ServerGuide won't
start your NOS CD.
Can't install NOS -
option is grayed out.
Setup
Netfinity Setup and
Installation CD won't
start.
140
Netfinity 3500-M20 – Type 8657 Models 21Y, 22Y, 31Y, 32Y,
• Be sure the server is
supported; all Netfinity
servers with a startable
(bootable) CD-ROM drive are
supported.
• If the startup (boot) sequence
settings have been altered,
be sure the CD-ROM is first
in the boot sequence.
• If more than one CD-ROM
drive is installed, be sure that
only one drive is set as the
primary drive. Start the CD
from the primary drive.
• Be sure there are no
duplicate SCSI IDs or IRQ
assignments.
• Be sure that the hard disk
drive is connected properly.
Free up more space on the hard
disk.
Be sure the NOS CD you have is
supported by ServerGuide. See
the Netfinity Setup and Installation
CD label for a list of NOS versions
supported.
Either there is no logical drive
defined (ServeRAID systems) or
the ServerGuide system partition
is not present. Run the setup and
configuration program.
• Be sure the server is
supported; all Netfinity
servers with a startable
(bootable) CD-ROM drive are
supported.
• If the startup (boot) sequence
settings have been altered,
be sure the CD-ROM is first
in the boot sequence.
• If more than one CD-ROM
drive is installed, be sure that
only one drive is set as the
primary drive. Start the CD
from the primary drive.
Action
Action