Final Installation; Rockwool Placement; Log Placement; Lava Rock And Ember Placement - MHSC CDVR33 Installation And Operating Instructions Manual

CDV Series Gas Fireplace
ROCK WOOl plACEMENT
1. Place rock wool on burner to provide glowing
embers. For best results, pull the rock wool
apart into pieces the size of a dime or smaller.
NOTE: Embers must be loosely placed to allow
proper burner flame.
2. Distribute one layer of rock wool to cover the
entire burner. Figure 50
3. Place the logs on the burner. See Log Place-
ment below. Light unit and after 15 minutes,
check burner flame and glow. Refer to Burner
Flame, Page 41.
If the flame is blue and only in the center, turn off
unit and let cool. After unit cools, remove logs. If
the back holes are clear, add more rock wool to the
center of the burner. Replace logs and check flame
again. Save left over rock wool to refresh when
cleaning later. Too much rock wool can disturb the
flame and cause sooting on the glass or logs.

lOG plACEMENT

1. Place rear log (#1) on grate assembly. Log should rest
firmly on the two log mounting pins shown. Figure 51
2. Place top right log (#2) on the rear log. Rest the right
back side of the log in the flat area of the rear log. Place
the narrow front end of the log next to the center vertical
grate bar. Figure 51
3. Place the top left log (#3) on the rear log. Nest the
forked end of the top left log into the fork or the rear
log. Rest the narrow end of the top left log behind the
center vertical grate bar. Figure 51

lAVA ROCK AND EMBER plACEMENT

Sprinkle lava rock on the floor of the inner combustion
chamber. Evenly distribute the rock. Do not pile the lava rock
up in front of grate. Do not place lava rock on the burner.
If desired, purchase optional embers to decorate the floor
of the fireplace.
Do not sprinkle the lava rock or ember
chunks on top of the burner. This may
cause potential sooting, glass breakage
and a fire hazard.
36
Cover with
Rock Wool
Figure 50 - Placement of Rock Wool on Burner
Do not use the entire bag of rock wool
to cover the burner. This could cause
the flame to burn poorly and may lead
to sooting.
(#1) Rear
Log
Log Mounting Pins
Left Vertical
Grate Bar
Center Vertical
Grate Bar
Figure 51 - Log Placement

FINAl INSTAllATION

Burner
(#3) Top
Right Log
Left Log
Vertical
Grate Bar
(#2) Top
Flat
Area
Right
69D0023