Installation Information; Installation Precautions - MHSC CDVR33 Installation And Operating Instructions Manual

INSTAllATION INFORMATION

FINIShING MATERIAl
NOTE: Any wiring (i.e. remote control, wall switch, and optional fan) must be done prior to final finishing
to avoid costly reconstruction.
Only noncombustible materials (i.e. brick, tile, slate, steel, or other materials with a UL fire rating of Zero) may be used to
cover the black surface of the appliance. A 300
surface. If joints between the finished wall and the fireplace surround are sealed, a 300
Electric RTV103 or equivalent) must be used.
Read all instructions completely and thoroughly before attempting installation. Failure
to do so could result in serious injury, property damage or loss of life. operation of
improperly installed and maintained venting system could result in serious injury,
property damage or loss of life.

INSTAllATION pRECAuTIONS

Consult local building codes before beginning the installation. The installer must make sure to select the proper
vent system for installation. Before installing vent kit, the installer must read this fireplace manual and vent
kit instructions.
Only a qualified installer/service person should install venting system. The installer must follow these safety
rules:
•
Wear gloves and safety glasses for protection.
•
Use extreme caution when using ladders or when on rooftops.
•
Be aware of electrical wiring locations in walls and ceilings.
The following actions will void the warranty on your venting system:
•
Installation of any damaged venting component.
•
Unauthorized modification of the venting system.
•
Installation of any component part not manufactured or approved by MHS.
•
Installation other than permitted by these instructions.
69D0023
Never obstruct or modify the air inlet
or outlet grills (louvers). This may
create a fire hazard.
°
F minimum adhesive may be used to attach facing materials to the black
Failure to follow these
instructions will void the
warranty.
CDV Series Gas Fireplace
°
F minimum sealant material (General
VENT INSTAllATION
13