Electronic Ignition Operating Instructions; What To Do If You Smell Gas; Lighting Electronic Ignition; To Turn Off Gas - MHSC CDVR33 Installation And Operating Instructions Manual

Cdv series direct vent gas fireplace

Hide thumbs

Table Of Contents

Table of Contents

CDV Series Gas Fireplace

FOR yOuR SAFETy READ BEFORE lIGhTING

A. This appliance is equipped with an ignition

device (Piezo) which automatically lights

the pilot. Do NOT try to light the burner by

hand.

B. BEFORE OPERATING smell all around the

appliance area for gas. Be sure to smell next

to the floor because some gas is heavier than

air and will settle on the floor.

WhAT TO DO IF yOu SMEll GAS:

•

Turn off all gas to the appliance.

•

Open windows.

•

Do not attempt to light any appliance.

•

Do not touch any electric switch; do not use any phone in your building.

•

Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instruc-

tions.

•

If you cannot reach your gas supplier, call the fire department.

C. Turn off all electric power to appliance.

D. Do not use this appliance if any part of it has been under water. Immediately call a qualified ser-

vice technician to inspect the appliance and to replace any part of the control system and any

gas control that has been under water.

1. STOp! Read the safety information above.

2. Set switch to off.

3. Turn off electric power to the appliance.

4. This appliance is equipped with an ignition device

which automatically lights the burner. Do not try to

light the burner by hand.

5. Wait 5 minutes to clear out any gas. Then smell for

gas, including near the floor. If you smell gas STOP!

Follow "B" —

step.

6. Turn on all electric power to appliance.

7. Turn RS-OFF-ON rocker switch to "ON".

8. If the appliance will not operate, follow the instruction

technician or gas supplier.

1. Open lower door.

2. Turn RS-OFF_ON rocker switch to "OFF".

3. Turn off all electric power to the appliance if service is to be performed.

4. Close lower door.