Troubleshooting - Capresso 119 Instructions Manual

Decalcifying the Brew Head
1. Remove the portafilter.
2. For best results unscrew the screen inside the brew head. Wipe off any
coffee residue with a damp cloth.
3. Fill the water tank with the decalcifying solution.
4. Place a large bowl beneath the brew head.
5. Push the ON/OFF button on the back of the machine and turn the Brewing
Control Knob clockwise to the brewing position towards the "Cup icon".
Allow 1/3 to 1/2 of the solution to be pumped through the system and the
brew head.
NOTE: There is no need to wait for the READY light to illuminate.
6. Turn the Brewing Control Knob counterclockwise to the OFF position to
stop the process.
7. Let the machine sit for approximately 10 minutes.
Decalcifying the frother
8. Remove the black frothing sleeve.
9. Fill a pitcher with 6 to 8 oz. of cold water and immerse the frothing wand
into the cold water.
10. Turn the Steam Control Knob on the side of the machine clockwise to the
"Steam icon" and let the steam pass through for about 30 seconds.
Repeat this process three or four times.
11. Now process the remaining decalcifying solution through the brew head as
described above.
Cleaning the system
12. Remove the water tank and rinse thoroughly, then fill with fresh cold water.
13. Repeat above steps (4 through 7) with fresh cold water.
14. Replace screen in the brew head and tighten the screw securely.

11. Troubleshooting

Coffee runs down the side of the portafilter.
Cause: Portafilter is not properly inserted.
Correction: Turn the handle of the portafilter further to the right.
Cause: Edge of sieve is not free of ground coffee.
Correction: Switch off the appliance, remove the portafilter holder and clean the
edges of the sieve.
Cause: Screen inside brew head is dirty.
Correction: Remove the screen in the brew head by removing the center screw
(a dime can be used to remove the screw), clean thoroughly with
warm water, dry and replace the screen. Ensure the center screw is
tightly fixed back on. CAUTION! HOT.
Cause: Sealing ring lost its elasticity.
Correction: Sealing ring must be replaced. Contact Customer Service to order.
13.