Table of Contents
Advertisement
3. Front left small log
Refer fully assembled image for reference. Place onto the
middle left locating pin and left front locator bracket.
3
5. Front middle small log
Refer fully assembled image for reference. Place onto the
middle locating pin and central front locator bracket.
5
7. Front large middle log
Place onto the locating pin of log four and slot onto the
right front locating bracket.
Adding the granules
The granules as well as being added to create
a more realistic log flame affect (by diffusing
the gas flames through the burner ports) also
assist in soot prevention and are CRITICAL to
the performance of the heater. Never pour the
granules directly from the pack as dust particles
from the plastic bag may block the ports.
DO NOT place the granules in the left hand
operational area (highlighted) and DO NOT have
them touching the flame rod as this will cause a
blockage and the unit will not start.
Place the granules evenly (do not stack) around
the logs in the front part of the burner and on the
middle section of the burner (in the gaps between
the logs)—refer fully assembled image.
7
4. Front right small log
Refer fully assembled image for reference. Place onto the
middle right locating pin and right front locator bracket.
6. Front large left log
Place onto the locating pin of the first log and slot onto
the left front locating bracket.
6
8. Top upper right large log
Place onto the locating pin of log seven and swivel OVER
log 4 so the end rests into the burner slot.
Evolve 950 Installation Guide: 12471-A 01-14 | 17
4
8
Advertisement
Table of Contents
