Operation - Poulan Pro ES35 Instruction Manual

For Parts Call K&T 606-678-9623 or 606-561-4983
KNOW YOUR SAW
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
Compare the illustrations with your unit to familiarize yourself with the
CHAIN SAW.
location of the various controls and adjustments. Save this manual for future refer-
ence.
Bar Oil Cap
Trigger Lock--out
Button
Power
Cord
Trigger
Switch
TRIGGER SWITCH
The is used to turn on
TRIGGER SWITCH
the unit. Squeeze the trigger switch to
operate the unit after lock--out button
has been pushed forward. Release the
trigger to turn the unit off.
TRIGGER LOCK- -OUT BUTTON
The
TRIGGER LOCK--OUT BUTTON
control feature designed to prevent the
motor from being accidently started.
When the rear handle is gripped in a nor-
mal cutting position, the lock--out button
can be pushed in by the thumb, permit-
ting the index finger to squeeze the trig-
ger. It is not necessary to maintain pres-
sure on the lock--out button once the
trigger has been engaged.
OPERATING INSTRUCTIONS
Use only a voltage supply as specified on
your unit.
SELECT AN EXTENSION CORD
MINIMUM WIRE GAUGE
RECOMMENDATIONS
50 ft.
25 ft.
Volts
(15.24 m)
(7.67 m)
16 16
120
A.W.G.* A.W.G.*
*American Wire Gauge
ATTACH THE EXTENSION CORD TO
YOUR CHAIN SAW
To prevent disconnection from unit, se-
cure extension cord to power cord as
shown in the following illustration.

OPERATION

Hand Guard
Chain Adjustment Screw
Bar
Oil Level
Bar Clamp
Indicator
BAR OIL CAP
The
BAR OIL CAP
tank.
CHAIN ADJUSTMENT SCREW
The
CHAIN ADJUSTMENT SCREW
used to adjust the chain tension.
POWER CORD
The
POWER CORD
is a
the chain saw to an approved extension
cord.
CHAIN TENSION
It is normal for a new chain to stretch dur-
ing first 15 minutes of operation. You
should check your chain tension frequent-
ly. Readjust chain after every 15 minutes
of operation. See
under the
MAINTENANCE
Power Cord
Extension Cord
100 ft.
BEFORE STARTING SAW
(30.48 m)
14
WARNING:
A.W.G.*
electrical safety information in the safety
rules section of this manual before you
begin. If you do not understand the elec-
trical safety information do not attempt to
use your unit. Seek help from someone
that does understand the information or
call the customer assistance help line at
1-800-554-6723.
7
www.mymowerparts.com
Bar Sprocket
Chain
Hole
is used to fill the bar oil
is
is used to connect
CHECK CHAIN TENSION
section.
Be sure to read the