Leveling And Door Alignment - Kenmore BOTTOM FREEZER 795.713 Use And Care Manual

LEVELING AND DOOR ALIGNMENT Door Alignment
Leveling
Your refrigerator has two front leveling screws, one on the right
and one on the left. If your refrigerator seems unsteady or you
want the doors to close easier, adjust the refrigerator's tilt using
the instructions below:
1. Plug the refrigerator's power cord into a 3-prong grounded
outlet. Move the refrigerator into its final position.
2. Turn the leveling screw clockwise to raise that side of the
refrigerator or counterclockwise to lower it. It may take
several turns of the leveling screw to adjust the tilt of the
refrigerator.
NOTE: Having someone push against the top of the
refrigerator takes some weight off the leveling screws. This
makes it easier to adjust the screws.
\\
if the space between your doors is uneven, follow the
instructions below to align the doors:
|. With one hand, lift up the door you want to raise at middle
hinge.
2. With other hand, use pliers to insert snap ring as shown.
3. insert additional snap rings until the doors are aligned.
(Three snap rings are provided with unit.)
3. Open both doors again and check to make sure that they
close easily. If not, flit the refrigerator slightly more to the
rear by turning both leveling screws clockwise. It may take
several more turns, and you should turn both leveling screws
the same amount.
4. Re-adjust if necessary.
5. Replace the base cover.
NOTE: Your new refrigerator is uniquely designed with two
fresh food doors. Either door can be opened or closed
independently of one another. You may have to exert slight
pressure on doors to get them to dose completely.
15