Leveling And Door Alignment - Kenmore 795.7902 Series Use & Care Manual

9. Turn the middle hinge bracket upside down and
position it on the left side of the refrigerator. Reattach
it using two Allen-head screws and a Phillips-head
screw.
10. Reattach the middle hinge pin using a 1/4 in.
(6.35 mm) socket wrench.
NOTE: The bracket has been flipped, but the hinge
pin stays in the same orientation, with its
hexagonal end facing up.
11. Insert the decorative screw into the outer hole on the
right side of the flange. Attach the cover on the right
side. Cover is force-fitted.
12. Loosen the 2 screws and remove the left hinge cap.
13. Place the refrigerator door down over the hinge pin
on the middle hinge pin bracket.
NOTE: The left top hinge, right hinge cap and left
hinge cover are provided for reversing door.
14. Line up the left top hinge with holes in top of
refrigerator. Insert and tighten the three bolts in the
hinge. Replace the left hinge cover and insert the two
screws.
15. Assemble the right hinge cap with the 2 screws.
LEVELING
The refrigerator has two front leveling legs. Adjust the
legs to alter the tilt from front-to-back or side-to-side. If
the refrigerator seems unsteady, or the doors do not close
easily, adjust the refrigerator's tilt using the instructions
below:
Tools required: 11/16" (18mm) wrench or flat-blade
screwdriver.
1. Turn the leveling leg to the left to raise that side of
the refrigerator or to the right to lower it. It may take
several turns of the leveling leg to adjust the tilt of the
refrigerator.
NOTE: A flare nut wrench works best, but an open-end
wrench will suffice.
NOTE: Having someone push backward against the
top of the refrigerator takes some weight off of the
leveling legs. This makes it easier to adjust the legs.
17
REFRIGERATOR INSTALLATION