Test The Path From Your Computer To A Remote Device - NETGEAR D6100 User Manual

AC1200 WiFi DSL Modem Router—Essentials Edition Model D6100

Test the Path from Your Computer to a Remote Device

After you verify that the LAN path works correctly, test the path from your computer to a
remote device:
1. From the Windows toolbar, click the Start button and select Run.
2. In the field provided, enter
ping -n 10 IP address
where IP address is the IP address of a remote device such as your ISP's DNS server.
If the path is functioning correctly, replies as described in
Router on page 215 display. If you do not receive replies, do the following:
• Check that the IP address of your modem router is listed as the default router in your
computer. If the IP configuration of your computer is assigned by DHCP, this information
is not visible in your computer's Network Control Panel. Verify that the IP address of the
modem router is listed as the default router.
• Check that the network address of your computer (the portion of the IP address specified
by the netmask) is different from the network address of the remote device.
• If your ISP assigned a host name to your computer, enter that host name as the account
name (see Manually Set Up the Internet Connection
• Your ISP might be rejecting the Ethernet MAC addresses of all but one of your
computers.
Many broadband ISPs restrict access by allowing traffic only from the MAC address of
your modem, but some additionally restrict access to the MAC address of a single
computer connected to that modem. In this case, configure your modem router to clone or
spoof the MAC address from the authorized computer (see
Connection on page 45).
Diagnostics and Troubleshooting
216
Test the LAN Path to Your Modem
on page 45).
Manually Set Up the Internet