Wire The Receivers - KVH Industries TracVision TV6 Installation Manual

11

Wire the Receivers

The steps for connecting the customer's
receiver(s) to the TracVision system and setting
them up depends upon the customer's satellite
TV service (see Figure 19 and Figure 20).
NOTE: KVH's TracVision Configuration Wizard,
available at www.kvh.com/tvseriesconfigurator,
displays a wiring diagram and parts list for all of the
most common configurations.
Follow the steps in the applicable section below
to wire the receivers. Then connect the receiver(s)
to the customer's television(s).
Linear. . . . . . . . . . . . . . . . . . . . . . . . page 14
DIRECTV (SWM) . . . . . . . . . . . . . . page 16
DIRECTV (Non-SWM) . . . . . . . . .
DIRECTV Latin America
Tri-Americas . . . . . . . . . . . . . . . . . . page 20
DISH Network/Bell TV
page 18
. . . . . . . page 19
. . . . . . . . page 21
Figure 19: TV-Hub A Receiver Connections
TV-Hub A
Figure 20: TV-Hub B Receiver Connections
TV-Hub B
13