Advertisement
Installing The Grill Head
1. Now that you've assembled
the grill cart you
can install the pre-assembled
Grill Head. See
Fig. 6a or 6b. If you haven't already done so,
we suggest you open the Grill Lid and remove
the packed components.
Even with the compo-
nents removed,
this next step requires 2
people.
BE CAREFUL
NOT TO PINCH FINGERS
WHEN LOWERING
HEAD ONTO CART
2. For LP Gas grills:
With an assistant,
lift and position the Grill
Head onto the grill cart. Place the
Pre-assembled
Valve Kit through the slot in side
of Grill Head as illustrated in Fig. 6a. Align the
4 holes of the Bowl Side Panel to the
threaded
holes on the Cart Leg Bracket.
Thread the Ignition Wire into the Wire Fastener.
Secure Wire Fastener to Right Rear Bowl location on
Grill Head by using 1 of the 1/4"xl/2" Pattern Head
Screws. Finish securing Grill Head to Cart by using
3 of the 1/4"xl/2" Pattern Head Screws provided.
3. For Natural Gas grills:
With an assistant,
lift and position the Grill
Head onto the grill cart. Place the
Pre-assembled
Valve Kit and Ignition Wire
through the slot in side of Grill Head as illus-
trated in Fig. 6b. Align the 4 holes of the
Bowl Side Panel to the threaded
holes on the
Cart Leg Bracket. Secure firmly by using 4 of
the
1/4"x 1/2" Pattern Head Screws provided.
Figure 6a (LP gas model only)
GRILL
HEAD
BOWL
SiDE
PANEL
tGN_TION WIRE
FROM GRILL HEAD
CART
LEG
\
WIRE
FASTENER
IGNITION WiRE
FROM GRILL HEAD
CART LEG
-LEFT
EMBLED
VALVE
KIT
- RIGHT
Figure
6b (Natural
gas
model
only)
GRILL HEAD
CART
LEG
BRACKET
BOWLStDE
PANEL
Installing
Manual Lighting
Stick
1.
Attach the Manual Lighting Stick to the Left
Bowl Support Bracket as shown in Fig. 7.
Align the hole at the end of Manual Lighting
Stick Wire with the threaded hole on the Left
Bowl Support Bracket. Tighten securely using
the M4x8mm Pattern Head Screw.
CART LEG
- LEFT
Figure 7
OUTSIDE
BOWL
PANEL-LEFT
M4xSmmPATTERN_
_
HEAD SCREW
MANUAL LIGHTIN'
STICK
VALVE
KiT
IGNIT_ON WIRE
FROM
GRILL
HEAD
16
Advertisement
