Console Operation - Horizon Fitness T-PRO Owner's Manual

CONSOlE OpERATION

Note: There is a thin protective sheet of clear plastic on the overlay of the console that should
be removed before use.
A) lARGE lEd dISplAy WINdOW: displays workout time.
b) AlpHANUMERIC dISplAy WINdOW: displays incline, distance, speed, calories,
pace, workout profile and heart rate.
C) START: press to begin exercising, start your workout, or resume exercising after pause.
d) STOp: press to pause/end your workout. Hold for 3 seconds to reset the console.
E) INClINE kEyS: used to adjust incline in small increments (0.5% Increments).
f) SpEEd + – kEyS: used to adjust speed in small increments (0.1 MPH or 0.1KM/H
increments).
G) QUICk AdjUST kEypAd: used to reach desired speed or incline more quickly.
H) SET INClINE kEy: used to change incline to level entered into keypad.
SET SpEEd kEy: used to change speed to level entered into keypad.
I)
j) ENTER / CHANGE dISplAy kEy: Press to confirm programming selections during
workout setup. Press to change display feedback during workout.
k) AUdIO IN jACk: plug your media player into the console using the included audio
adaptor cable.
l) AUdIO OUT / HEAdpHONE jACk: plug your headphones into this jack to listen to
your music through the headphones.
M) USb pORT: insert USB stick here to update software.
N) REAdING RACk: holds reading material.
O) MEdIA plAyER HOldER: holds your media player.
p) WATER bOTTlE pOCkETS: holds personal workout equipment.
Q) SAfETy kEy pOSITION: enables treadmill when safety key is inserted.
R) ENERGy SAVER: To minimize energy consumption, your machine will enter energy
saver mode automatically(after entering stand-by mode for 15 mins) and could be
quickly waken up with a touch of a button.
QUick adJUsT keYPad (g)
7 8
9
6
4
5
3
2
1
SET
0 SPEED
SET
GESCHWINDIGKEIT
EINSTELLEN
INCLINE
STEIGUNG EINSTELLEN
Quickly access any speed or
incline level by typing the number
and pressing SET SPEED (I)
or SET INCLINE (H) keys.
Examples:
• To change the speed to 6.5
MPH or KM/H, press 6–5–SET
SPEED.
• To change the incline to 10%,
press 1–0–0–SET INCLINE.
(NOTE: If there is no decimal
point, you still must enter 0).
17