Horizon Fitness T-PRO Owner's Manual page 10

T-pRO ASSEMBLY STEp 1
HARdWARE fOR STEp 1 :
BOLT (A)
20 mm
Qty: 8
LEFT CONSOLE MAST
BOLTS (A)
SPRING
WASHERS (B)
ARC WASHERS (C)
MAIN FRAME BRACKET
10
SPRING WASHER (B) ARC WASHER (C)
8.2 mm 8.4 mm
Qty: 8 Qty: 8
RIGHT CONSOLE MAST
LEAD WIRE
CONSOLE CABLE
A Open haRdwaRe fOR sTeP 1.
B Pull lead wiRe through RighT cOnsOle masT.
After pulling the lead wiRe through the mast, the
top of the cOnsOle cable should be located at
the top of the mast. Detach and discard lead wiRe.
NOTE: Do not pinch console cable when placing
the mast onto the main frame bracket.
Place RighT cOnsOle masT over main fRame
C
bRackeT.
D Attach cOnsOle masT to main fRame
bRackeT using 4 bOlTs (a), 4 sPRing
washeRs (b) and 4 aRc washeRs (c).
NOTE: Do not tighten bolts until step 3 is complete.
E Repeat steps C–D on other side.