Supervisor Password; Starting The Computer By Password - Toshiba tecra s3 User Manual

After using the token created for authentication, do not leave it inserted in
the SD card slot, ensure that the token is removed from the slot and stored
in a safe location. If the token is left in the slot, there is a danger of theft or
a third party using it for authentication and operating the user's computer
(resulting in extraction, modification or deletion of data) when the user is
not at their desk.

Supervisor Password

If you set a Supervisor Password, some functions might be restricted when
a user logs on with the User Password. To set a Supervisor Password,
execute the file TOSPU.EXE. The file is located at:
C:\Program Files\Toshiba\Windows Utilities\SVPWTool\TOSPU.EXE
This utility lets you do the following:
■
Register, delete or change the Supervisor Password.
■
Create or invalidate a Supervisor Password token.
This function in the TOSHIBA Password Utility lets you invalidate only
supervisor tokens or all tokens, including user and supervisor tokens.
■
Specify restrictions for general users.

Starting the computer by password

If you have already registered a password, there are three ways to start the
computer:
■
Insert an SD card token before you turn on the computer. The computer
will start normally, without displaying a password prompt.
■
Swipe your fingerprint on the sensor if you have already registered the
fingerprint with the Fingerprint utility and enabled Fingerprint System
Boot Authentication. If you would not like to swipe your finger or cannot
authenticate the fingerprint for some reasons, push the BkSp key to
skip the fingerprint authentication screen. You can try to swipe the
fingerprint up to five times. If you failed fingerprint authentication more
than five times, you must enter the password manually to start the
computer.
■
Enter the password manually.
The password is necessary only if the computer was shut down in boot
mode. It is not needed in Standby Mode.
To enter a password manually, follow these steps:
1. Turn on the power as described in Chapter 3,
following message will appear in the LCD:
S
2. Enter the Password.
3. Press Enter.
User's Manual
Password=
Power and Power-Up Modes
Getting Started. The
6-15