ZyXEL Communications 100-NH User Manual page 58

Chapter 6 Wireless LAN
Table 11 Wireless LAN > Wireless Settings: Root AP (continued)
LABEL
Wireless Mode
Channel
Channel Width
Select SSID
Profile
#
Active
Profile
Repeater Settings
The repeater function allows the NWA in root AP or repeater mode to set up a wireless connection between it
and another NWA in root AP or repeater mode.
Note: Repeater security is independent of the security settings between the NWA and any wireless clients.
Local MAC
Address
58
DESCRIPTION
If you are in the Wireless LAN > Wireless Settings or Wireless LAN > Wireless
Settings- 2.4G screen, you can select from the following:
• 802.11b/g to allow both IEEE802.11b and IEEE802.11g compliant WLAN devices to
associate with the NWA. The transmission rate of your NWA might be reduced.
• 802.11b/g/n to allow IEEE802.11b, IEEE802.11g and IEEE802.11n compliant WLAN
devices to associate with the NWA. The transmission rate of the NWA might be
reduced.
• 802.11n to allow only IEEE802.11n compliant WLAN devices to associate with the
NWA.
If you are in the Wireless LAN > Wireless Settings- 5G screen, you can select from
the following:
• 802.11a/n to allow IEEE802.11a and IEEE802.11n compliant WLAN devices to
associate with the NWA.
• 802.11a to allow only IEEE802.11a compliant WLAN devices to associate with the
NWA.
• 802.11n to allow only IEEE802.11n compliant WLAN devices to associate with the
NWA.
• 802.11a/n/ac to allow IEEE802.11a, IEEE802.11n and IEEE802.11ac compliant
WLAN devices to associate with the NWA. The transmission rate of the NWA might be
reduced.
Select the operating frequency/channel depending on your particular region from the
drop-down list box.
This field displays only when you select 802.11n, 802.11a/n, 802.11b/g/n or
802.11a/n/ac in the Wireless Mode field.
A standard 20MHz channel offers transfer speeds of up to 150Mbps whereas a 40MHz
channel uses two standard channels and offers speeds of up to 300Mbps. However, not all
devices support 40MHz channels.
Select the channel bandwidth you want to use for your wireless network.
It is recommended that you select 20/40MHz. This allows the NWA to adjust the channel
bandwidth depending on network conditions.
Select 20MHz if you want to lessen radio interference with other wireless devices in your
neighborhood or the wireless clients do not support channel bonding.
The SSID (Service Set IDentifier) identifies the Service Set with which a wireless station is
associated. Wireless stations associating to the access point (AP) must have the same
SSID. You can have up to four SSIDs active at the same time.
Note: If you are configuring the NWA from a computer connected to the wireless LAN and
you change the NWA's SSID or security settings, you will lose your wireless
connection when you press Apply to confirm. You must then change the wireless
settings of your computer to match the NWA's new settings.
This is the index number of each SSID profile.
Select the check box to enable an SSID profile. Otherwise, clear the check box.
Select an SSID Profile from the drop-down list box.
Local MAC Address is the MAC address of your NWA.
NWA1000 Series User's Guide