Panasonic KX-FT502ML Operating Instructions Manual page 25

Feature/Code
Receiving oversized
documents
{#}{3}{6}
Changing the display
contrast
{#}{3}{9}
Changing the fax activation
code
{#}{4}{1}
Setting the memory
reception alert
{#}{4}{4}
Setting friendly reception
{#}{4}{6}
Setting the auto
disconnection
{#}{4}{9}
Selection
To slightly reduce the received fax image when printing, so that the
received document will be approximately the same length as the original
document.
{0} "OFF": Deactivates this feature.
{1} "ON" (default): The received fax image will be printed slightly smaller
than the original image.
Note:
L A slight margin will be added to the printed documents, and therefore if
this feature is turned OFF, the received document will be slightly longer
than the original document.
{1} "NORMAL" (default): For normal contrast.
{2} "DARKER": Used when the display contrast is too light.
If you wish to use an extension telephone (page 19) to receive faxes,
activate this feature and program the activation code.
{0} "OFF"
{1} "ON" (default)
1. Press {Menu}.
2. Press {#}, then {4}{1}.
3. Rotate {Easy Dial} to select "ON".
4. Press {Set}.
5. Enter your code (2 to 4 digits) using the dial keys {0}-{9}, {*} and
{#}.
L The default code is ";#9".
6. Press {Set}.
7. Press {Menu}.
To alert you with a beeping sound when a received fax document is stored
into memory due to some existing problem.
The slow beeps will continue until you clear the printing problem and make
sure the unit is supplied with enough paper to print the stored document.
{0} "OFF": Deactivates this feature.
{1} "ON" (default): You will be alerted to a reception problem by a beeping
sound.
To receive a fax automatically when you answer a call and hear a fax
calling tone (slow beep).
{0} "OFF": You have to press {Fax/Start} for fax reception.
{1} "ON" (default): You do not have to press {Fax/Start} for fax reception.
To answer a call with another telephone connected to the same telephone
line as the unit in TEL/FAX mode (page 19), activate this feature and
program the code.
{0} "OFF"
{1} "ON" (default)
1. Press {Menu}.
2. Press {#}, then {4}{9}.
3. Rotate {Easy Dial} to select "ON".
4. Press {Set}.
5. Enter your code 2 to 4 digits, using 0-9 and {*}.
L The default code is ";0".
6. Press {Set}.
7. Press {Menu}.
7. Programmable Features
25