Windsor Voyager 2 VGR2 Operating Instructions Manual page 12

MAINTENANCE
WWW.MANUALS.WS
MANIFOLD / SPRAY JETS
To prevent clogged jets due to alkaline build-up, the spray system should be flushed with 1 gallon of clean hot
water at the end of each work day. The VOYAGER2 is equipped with "quick change" jets that can be easily
removed for cleaning. To remove – push jet in and rotate. Do not use pins or wire to remove obstruction as this
will damage jet and alter spray pattern.
1 66095 PLUG, 1/8 NPT HEX BRASS
2 44052 JETBODY, BRASS W/SEAL
3 54138 MANIFOLD ASM, 3 JET
4 40033 HOSEBARB, 1/4 MPT X 3/8 90D
5 66052 PIN, 1/8 X 1.0 ROLL
6 73576 SPRING, 2" X .600 OD
7 44060 JET, 8002 MINI-QUICK REPLACEMENT
8 44051 JET SEAL, MINI QUICK
9 54162 MANIFOLD A
VAC SHOE TRACKING
To adjust shoe tracking, move eyebolts in or out to increase or decrease spring force, respectively, until desired
tracking is reached.
VAC SHOE DOWNPRESSURE
NOTE: DOWNPRESSURE IS FACTORY SET AND SHOULD NOT REQUIRE ADJUSTMENT.
If adjustment of downpressure is required, turn black knob on top of vac shoe clockwise to increase
downpressure and counterclockwise to decrease downpressure.
CASTER ASM.
REF.
VAC SHOE
PIVOT ASM.
REF.
VAC SHOE ANGLE
NOTE: THE ANGLE OF THE VAC SHOE IS FACTORY
SET AND SHOULD NOT REQUIRE ADJUSTMENT.
Periodically inspect the vac shoe angle by resting it
on a hard, flat surface. Use a square to verify a 90°
angle between the floor and vertical surface of the
vac shoe.
If adjustment is required, remove one socket on each
lower arm (from the vac shoe or bracket) and turn
WWW.MANUALS.WS
clockwise or counterclockwise to change the angle to
the recommended 90°. Attach the socket on each
arm to its respective location and recheck the angle
using the square. Repeat if necessary.
12
DOWNPRESSURE KNOB
VAC SHOE
TRACKING
98953 02/14/04
9
4
1
2
REF.
SIDE VIEW OF VAC SHOE
VAC SHOE
REF.
PIVOT ASM.
REF.
SOCKET
ARM
REF.
ADJUSTMENT
NUTS. REF.
FLAT SURFACE
6
1
3
5
"Quick
8
7
Change
Jets"
VAC SHOE
REF.
VERTICAL
SURFACE
OF VAC
SHOE
90°
SQUARE