Log Commands; Displaying Logs - ZyXEL Communications ZyWall 10 Reference Manual

Log Commands

Go to the command interpreter interface (the Command Interpreter Appendix explains how to access and use
the commands).
Use the sys logs load command to load the log setting buffer that allows you to configure which logs
the ZyWALL is to record.
Use sys logs category followed by a log category and a parameter to decide what to record
LOG CATEGORIES
access
attack
error
ike
ipsec
javablocked
mten
upnp
urlblocked
urlforward
Use 0 to not record logs for that category,
alerts for that category, and
Use the sys logs save command to store the settings in the ZyWALL (you must do this in order to
record logs).
Use the sys logs display command to show all of the logs in the ZyWALL's log.
Use the sys logs category display command to show the log settings for all of the log categories.
Log Descriptions
Configuring What You Want the ZyWALL to Log
Chart 13-13 Log Categories and Available Settings
3 to record both logs and alerts for that category.

Displaying Logs

ZyWALL 10~100 Series Internet Security Gateway
AVAILABLE PARAMETERS
0, 1, 2, 3
0, 1, 2, 3
0, 1, 2, 3
0, 1, 2, 3
0, 1, 2, 3
0, 1, 2, 3
0, 1
0, 1
0, 1, 2, 3
0, 1
1 to record only logs for that category, 2 to record only
13-17