Table of Contents
Advertisement
10. DEPARTMENT MANAGEMENT (Cont.)
Setting Access Codes (Registration/Change/Deletion) (Cont.)
Registering New Access Code and Limit Number of Outputs
1
4
Key in the desired access code (5 digits) into the fields
of NEW ACCESS CODE and CONFIRM ACCESS
CODE, and press the SET key.
2
- You cannot key in the access code which has already been
registered. The administrator password and "00000" are
invalid.
3
4
5
Key in the upper limit (7 digits) you want to set on
the number of copies in "TOTAL" and "COLOR" re-
spectively, and then press the SET key.
- Press the TOTAL (or COLOR ) key, and then set the limit
5
number of outputs (limitation).
- The limit number of outputs (limitation) for "TOTAL" is the
total copy number of "full color + monocolor + black". The
limit number of outputs for "COLOR" is the total copy num-
6
ber of "full color + monocolor". Key in the number between
1 and 9999999.
- If the number of copies has exceeded the limit number of
outputs (limitation), no more copies can be made under
7
this access code after the current operation has been com-
pleted. However, in case that the number of copies for
"COLOR" has exceeded the set limit number and that for
"TOTAL" has not exceeded the set limit number, the black-
and-white copy is still available.
8
- To make the copy operation available again, key in the limit
number of copies (limitation) larger than the current one, or
reset the number to 0 (zero) by the clear counter function
(
Page 6-29).
9
- Press the DISABLE key if the limitation to the new depart-
ment is not necessary.
6
When the optional printer controller is installed, press
10
the Next key in the screen of step 5, and then set the
limit number of prints (7 digits).
- The setting method is same as that for copies.
11
12
6-26
USING THE SPECIAL FUNCTIONS
Advertisement
Table of Contents
