Yamaha QY100 Service Manual page 41

Bad File This message will appear if you attempt to access a broken file.
Illegal Format The card you are attempting to access has not been properly format-
ted for use with the QY100.
Cannot Open The specified file cannot be loaded.
Wrong ID You have attempted to load a file that was not saved using the QY100
format.
SMF Error[00] You have attempted to load an SMF file but the file to be loaded does
not have the proper SMF format.
Improperly formatted files cannot be loaded.
SMF Error[03] You have attempted to load an SMF file in which the header chunk divi-
sion data is not compatible with the QY100.
Incompatible files cannot be loaded.
SMF Error[06] The actual length of the SMF files you attempted to load was different
from the length specified by the file's length data.
The file may be corrupted. If possible, use an external device to re-
save the data to the memory card and try again.
SMF Error[07] You have attempted to load an SMF file which contains an incorrect
status byte.
Incompatible files cannot be loaded.
SMF Error[08] You have attempted to load an SMF file which contains an incorrect
data byte.
Incompatible files cannot be loaded.
Not Format0 This message will appear if you attempt to load an SMF file that was
saved in format other than SMF Format 0.
Incompatible files cannot be loaded.
SMF Error[**] An SMF error other than those listed above has occurred.
Incompatible files cannot be loaded.
Card Error[**] A memory card error other than those listed above has occurred.
Try re-inserting the memory card and pressing the [CARD] button. If
the error continues to occur, the memory card may be damaged.
Messages other than error messages
Can't Undo OK? (Yes/No) If executing a job would fill up the internal memory so that Undo will
not be available, this message will appear. If you are sure that you will
not need to Undo this job, press "YES". To cancel without executing
the job, press"NO".
Are You Sure? (Yes/No) Before an operation is executed, this message will ask you for confir-
mation. To execute the operation press "YES". To cancel the operation
press "NO".
Completed This will appear when the current process has been completed.
Executing... This message will appear while the job is being executed. Please wait.
Transmitting... When transmitting MIDI bulk data, this message will appear.
Receiving... When receiving MIDI bulk data, this message will appear.
QY100
41